Residential solutions
TV Mounting and Installation in Dallas–Fort Worth
TV mounting in Dallas–Fort Worth with wire concealment and above-fireplace mounts, scoped from the wall and the set.

- Stud, masonry, and tile walls
- Fixed, tilt, full-motion, pull-down
- Signal cable marked for its run
- Soundbar on the same wall
- Outdoor TV and mounting-location assessment
- Level set and a remote demonstration
Before the proposal
What decides your project
The inputs that size the work, then what a proposal includes and what you supply.
Which television is it?
Send the TV model from the label on the set. The bracket has to match that model.
What does the wall look like?
Send wall photos, including the area over a fireplace if that is the spot.
Where is the outlet?
Send the outlet location, and a photo that shows the receptacle relative to the television.
Where do you sit?
Tell us the seating position you watch from. That seat is what we use for mounting height.
Is there a soundbar or a patio?
Say whether a soundbar shares the wall, or whether the set is for a covered patio, and send a photo of that spot.
Scope ledger
Confirmed in writing before equipment is ordered.
- Included in the proposal
- Site check, mount plan, and the wire path you approve
- Bracket, anchors, level, and the cable path in that plan
- Picture settings, soundbar level if one is part of the job, and a demonstration of the remote controls
You or facilities provide
- The television, or the model number on the label
- The wall and the seats you watch from
- Where the outlet is today
- Fireplace, soundbar, or patio, if those are part of the job
Local team and service area
Local team
Digitalholics LLC
8105 Rasor Boulevard, Suite 211, Plano, TX 75024
Packages
What changes the scope
The wall, the fireplace, and the cable path are what move the quote.
Stud-wall mount
One television on wood or metal studs, with the cord still reachable.
- Fixed, tilting, or full-motion mount matched to the set
- Stud location and a level screen
- Surface channel when the wall stays closed
Fireplace or masonry
A set on brick, stone, tile, or the wall above a fireplace.
- Masonry anchors or a steel-stud plan
- A tilting mount angles the screen but leaves it high. A compatible pull-down can lower it when the instructions allow
- A check of heat on the surface over the opening
Concealed cable
The same mount, with signal cable marked for the wall and run out of sight.
- Power-limited circuit cable only when the signal is that cable type
- Signal cable inside the wall where it can open
- Soundbar on the same path when it is part of the job
Overview
How we approach the work
A television mount is a bracket, a wall, and a path for the cable. Wood studs, metal studs, brick, stone, and tile each take different hardware. The office is 8105 Rasor Boulevard, Suite 211, Plano. The cities we cover are listed on the service areas page.
The crew that mounts your television is the crew that installs our home theaters and whole-home audio and video. A mount can be a one-wall job, or the first step of a larger room.
Fixed mounts hold the set flat to the wall. Tilting mounts tip the screen down. Full-motion arms swing the set off the wall. Height starts from the chair you actually use.
A tilting mount angles the screen toward the seats but leaves it high. A compatible pull-down mount can lower it for viewing. A set goes above a fireplace only when that television's instructions, the heat from that fireplace, and the mount instructions all allow it. The mount has to clear the mantel.
The screen-size tool uses horizontal viewing-angle presets of 30, 40, and 50 degrees for choosing screen size from that seat.
We select signal cable marked for its cable type and installation location. Where the run is power-limited circuit cable, UL's wire and cable marking guide lists types CL2, CL2R, CL2P, CL3, CL3R, and CL3P with NEC Article 725. Communications cable, community-antenna television cable, and optical-fiber cable are listed under their own type letters.
The signal cable can run inside the wall to a plate behind the set. When the wall cannot be opened, the cords stay in a paintable channel on the surface.
A soundbar can go on the same wall, under the set, on a mount matched to the bar. Surround speakers in the ceiling or on the side walls are a larger audio job. A patio television is a different panel from a living-room set. Sun, rain, and the cover over the seats decide it. See outdoor TVs for Texas heat. A bracket with concealed cable stays here. Millwork, a rack, and a room built around the screen belong on home theater. The same picture in several rooms belongs on whole-home audio and video.
The wall decides the hardware: studs, masonry, or the stone over a fireplace.
Which mount fits the wall
| Wall | Mount to discuss |
|---|---|
| Wood or metal studs | Fixed, tilting, or full-motion |
| Brick, stone, or tile | Masonry anchors, not drywall hardware |
| Above a fireplace | Only when the set, the fireplace, and the mount instructions allow it. Tilt angles the screen and leaves it high. A compatible pull-down can lower it. |
| Covered patio | A weather-rated set, not a living-room panel |
Our Process
From the wall check to the remote
Five steps, from the phone call to the remote in your hand.
Site check
Call (469) 666-0747 and name the wall, the television, and the seats. Wood studs, metal studs, brick, stone, tile, and a fireplace are different visits. Mon–Fri 9:00 AM – 6:00 PM · Sat 10:00 AM – 1:00 PM.
Mount and wall plan
We match a fixed, tilting, full-motion, or pull-down mount to the set and the wall. Fireplace heat, mantel clearance, and viewing height are part of that plan. You approve the scope before holes are drilled.
Wire path
We trace the signal cable path and note where the existing outlet sits. Signal cable is marked for its type and for where it runs. On a finished wall that cannot open, the cords stay in a surface channel.
Mount and level
Anchors go into the structure the site check named. The bracket is lagged or bolted, the set is hung, and the screen is leveled to the room, not to a crooked mantel.
Calibrate and hand over
Picture settings follow the light in that room. A soundbar, if one is part of the job, gets a level check. We demonstrate the remote controls before we leave. Later changes start with a call to (469) 666-0747.
Property Types
The wall you are standing at
Mounting requirements vary with the wall construction.
Wood or metal studs
Wood studs take the mount into the stud. Metal studs are thin, so the plan is a plywood backer or anchors made for steel. The site check says which.
Brick, stone, or tile
Masonry anchors, not drywall hardware. Tile has to stay intact, and the anchor has to reach structure behind the glaze.
Above a fireplace
That wall is used only when the television's instructions, the fireplace, and the mount instructions allow it. A tilting mount angles the screen toward the seats but leaves it high. A compatible pull-down mount can lower it for viewing.
Covered patio
A weather-rated panel, not the living-room set. Sun, rain, and the cover over the seats decide the panel. Indoor rooms that share the picture belong on the whole-home page.
Common Questions
Questions about TV Mounting
01Can you mount a TV above a fireplace?
A set goes above a fireplace only when that television's instructions, the heat from that fireplace, and the mount instructions all allow it. We look at the stone, brick, or tile and at how far the mantel projects. A tilting mount angles the screen toward the seats but leaves it high. A compatible pull-down mount can lower it for viewing. The mount instructions also set how close the set may come to the mantel.
02Can you hide the wires in the wall?
We select signal cable marked for its cable type and installation location. Where the run is power-limited circuit cable, types CL2, CL2R, CL2P, CL3, CL3R, and CL3P go with NEC Article 725. That cable runs inside the wall to the space behind the set when the wall can be opened. A surface channel is the path when the wall cannot be opened.
03How high should a TV be mounted?
Sit in the chair you use and note eye level. On a stud wall the middle of the screen can sit near that line. Above a fireplace the screen stays high. A tilting mount angles the screen toward the seats but leaves it high. A compatible pull-down mount can lower it for viewing when the mount instructions allow that move. The screen-size tool uses horizontal viewing-angle presets of 30, 40, and 50 degrees for choosing screen size, and it does not set the mounting height.
04Can you mount on brick or stone?
Yes. Brick and stone usually take masonry anchors, chosen after we check what is behind the face and how thick it is. Drywall toggles are the wrong hardware there. Tile over a fireplace surround needs a bit that does not crack the field, and the anchor has to reach structure behind the tile, not only the glaze. Metal studs are a separate case: the stud is thin, so the mount often lands on a plywood backer or on anchors made for steel studs. The site check names that hardware.
05What size mount do I need?
The mount has to match the hole pattern on the back of the television and the weight of that set. A bedroom set and a large living-room set are not the same bracket. Full-motion arms are heavier hardware than a fixed plate because the arm holds the set away from the wall. Bring the model number, or we read the label on site and match the bracket to it.
06Do you install soundbars?
Yes. The bar can hang under the television or on the wall just below it, on a mount matched to the bar so it does not block the screen or the remote sensor. The cable for the bar follows the same path as the television cable. Speakers in the ceiling or at the sides of the room are a larger audio job and move the scope off a single mount.
07Can you mount an outdoor TV?
Yes, where the location suits it. Outdoor televisions are built for the conditions an indoor set is not, so we match the set to how much sun and weather reach that wall. The hours you sit there and the cover over the seats decide the panel. The power-supply cord and the cable that stays in the wall are chosen separately. Flexible cords are listed under NEC Article 400. Cable left in the wall has to carry a marking for its type and for that location. See the outdoor TV guide, then tell us the wall and the seats.
Guides
More Residential
Complimentary Consultation
Ready to plan your space?
Tell us about your space and what you want it to do — if it is a fit, we book the walkthrough, then send a written, line-item proposal. You approve the scope before anyone books a crew.
- A complimentary phone consultation. No obligation.
- A written proposal before any work is scheduled.
- We aim to respond within one business day.





